Home
FARMS BUILT Jonabel Shadwell Kentuckiana Rood & Riddle Raceland INFORMATION Fence Types Fence Information Contact Us |
So you have finally decided which type of fence to install, now the question is how do you know that it is installed correctly? The first thing you need to pay attention to is how the post are drove or set into the ground. A 7'6" post should be in the ground 2'6" in the ground leaving about 5 foot sticking up. Most fence is run about 58" to 60" to the top of the board. If you see your contractor leaving alot of posts sticking up past 6' out of the ground then one of 2 things is happening.
Both of these situations will cause the fence to be weak and most importantly will decrease the life of your fence because it will simply fall over. Also these weak posts will start to loosen up when the ground finally does get some moisture, this will cause the posts to weave or lean over one way or the other. This makes a fence look about 30 years old and makes for a weak fence. If you have a board fence and the posts start to lean this will cause the boards to warp very fast. As you can tell in this picture the fence is ready to fall over. When you see a few posts all in a row like this that are falling over and the rest of the fence looks good this means that there is rock here and whom ever installed it did not drill out the rock and concrete the holes. The installation of the post is even more important when you are using polymer. The terminations (or any where the polymer ends at) needs to be concreted and braced. The terminations in polymer are the most importatant aspect of the fence installation, simply because the entire pressure of the fence is really held by the posts in the termination. If the end posts are not installed, concreted and braced right they will pull over from the tension of the polymer. The corners also need to be concreted but to a lesser extent since they do not have nearly the pressure the terminations have. Wire fence is also very important to install correctly, anywhere the fence ends or curves needs to have 9 foot tall gate posts and either be concreted, braced or both. As I have mentioned before wire can be curved to allow a safer field or paddock for your horses. Square corners are something everyone expects from wire fence, but that is not the case at all. We can make your wire curve and look just like a board fence curve. There are 3 main things to think about when deciding about square or rounded corners:
|